Pendant Overview
Description
The pendant is a wired Manual joystick control interface with a rubberized backlit keypad that is waterproof and rugged. This CANbus enabled controller is pluggable anywhere on the tractor communication backbone.
How to connect
The pendant must be connect to CAN/Power accessory port which is location on the back of the dashboard panel. (please reference photo below)
Pendant Controls
Joystick (omni directional stick that is used to control the amiga. This controls include, Acceleration, and turning left and right, reverse)
Cruise(X) – this will allow you to place your Amiga into
cruise control. To activate this,while the amiga is completely
stopped, press cruise then gently push forward the joystick to
accelerate, pull back on joystick to decrease acceleration. You
can press this button once more to exit cruise control and slow
to a stop.
Pushing forward and pulling back on the joystick does not control speed, only acceleration and how much it will accelerate in relation to the set speed on the dashboard home tab.
Brake(O) This is a brake for the Amiga. Pressing this will stop all motors and exit cruise control mode (if active).
PTO (Triangle) Power take-off (PTO) is a device that transfers an engine's mechanical power to another piece of equipment. A PTO allows the hosting energy source to transmit power to additional equipment that does not have its own engine or motor.
We use this to facilitate control from the pendant for addition equipment attached to the Amiga, such as the 3-point lift, compost spreader or cargo dump box
PAUSE(Square) Currently this button is a free button to be updated in future firmware releases.
ARROWS - UP, Down, Left, Right (these are used to control your connect and registered PTO device). Basic troubleshooting can found on our FAQ page
Calibrate pendant
See calibrate instructions here